Skip to main content
McMurdo Dry Valleys LTER
Code of Conduct
Areas of Research
Browse by Category
Streams Data Sets
Find Stream Field Notes
Streams Field Manual
Glacier Data Sets
Met Data Sets
Soils Data Sets
Lakes Data Sets
Genetic Data Sets
Restricted Data Access
Onyx at Vanda
Onyx at Lower Wright
Lakes Blue Boxes
East Lake Bonney
West Lake Bonney
Canada Glacier RT
Friis Hills RT
Howard Glacier RT
Lake Bonney RT
Lake Fryxell RT
Lake Hoare RT
Lake Vanda RT
Miers Valley RT
Mt. Fleming RT
Taylor Glacier RT
Data Explorer Dashboard
Techs and Staff
Glacier Stakes Map
Soil Projects Map
Education and Outreach
E&O Activities Submission Form
Chlorophyll-A Responses to Short-Term Soil Manipulation Experiment
A short-term soil manipulation experiment has been conducted as part of the McMurdo Dry Valleys Long Term Ecological Research (LTER) project. The chlorophyll-a concentration of soil samples was determined. Samples were taken on November 13, 1995, November 17, 1995, November 24, 1995 and December 11, 1995.
Long Term Manipulation Experiment at Hoare (LTM)
The experimental design is a randomized block, with 5 replicates per treatment. Within each block were 3 plots measuring approximately 1m x 1m, with a central circular area of 85 cm diameter (approx. 0.57 m2) used for treatments and sampling. The treatments were as follows:
(C) control plots (no manipulations),
(W) Nanopure water added to field capacity to 10 cm depth (5.6 L/plot),
(WS) sucrose added in solution (15.82 g sucrose in 5.6 L water per plot).
Soil samples were taken for chlorophyll-a analysis as follows: Sampling bags were prepared with one plastic vial and clean plastic teaspoon per sample. Samples were taken from within the 85 cm diameter circular area of each plot starting at the 12:00 position on the first day. The above treatments were then applied to the plots. The 3:00, 6:00 and 9:00 positions were then sampled for each successive date. Soil was collected to 1 cm depth with the plastic spoon, excluding rocks with a diameter >5 mm. About 4 teaspoons of soil were placed into the vial, keeping the
vial out of the light in a closed hand. The soil samples were stored in a light-tight bag, in a cooler for transportation. On return to the laboratory (within 8 hours of sampling), the soils were stored at +5 degrees C until further processing.
Extraction of chlorophyll from the soil. All procedures were carried out in the dark or very low irradiance to avoid degradation of the chlorophyll. The soil samples were mixed thoroughly in the vials, and a sample of approximately 5 g was weighed out into a 50 mL plastic centrifuge tube with a screw-top cap. 10 mL of a 50:50 DMSO/90% acetone solution was added to each sample and they were mixed thoroughly on a bench-top Vortex mixer for about 5 seconds. The vials were placed in a -4 degrees C constant temperature room, in the dark, and left for 12-18 hours.
Determination of chlorophyll-a concentration. This was determined fluorometrically using a Turner model 111 fluorometer. A calibration using a known concentration of chlorophyll was carried out prior to sample analysis. The machine was blanked using a 50:50 DMSO/90% acetone solution. Each vial was mixed thoroughly, then centrifuged for 5 minutes at about 1800 RPM. A sample of approximately 4 mL of the DMSO/acetone
solution was taken from the top of the sample with a pipette, being careful not to get any soil particles in the solution. The sample was placed in a cuvette, into the fluorometer and the fluorescence was recorded. This was done fairly quickly in order to prevent light from breaking down the chlorophyll. This measurement is called Fo, the initial fluorescence. After taking this reading, 0.1 mL of 1N HCl was added directly to the cuvette and the cuvette was gently agitated. After 20 seconds, the fluorescence was re-measured. (During this step, the acid converts the chlorophyll to phaeophytin by releasing a magnesium ion in an acidic environment). This measurement is called Fa, the fluorescence after acidification. The solution was discarded in to a waste container, and the cuvette rinsed 3 times with DMSO/90% acetone solution before proceeding with the next sample.
Calculation of chlorophyll concentration. The calibration curve that was constructed for the fluorometer had the following equation:
[chlorophyll (microg/L) = (Fo-Fa)-0.4254)/2.2385].
The Fo and Fa figures were put into this equation to calculate chlorophyll concentration. Subsequently, this figure was divided by 1000 to convert to microg/mL. Next, this was multiplied by 10 as the soil was extracted in 10mL of DMSO/90% acetone. Finally, this was divided by the fresh weight of the soil in g to give the concentration in microg chlorophyll per g fresh weight of soil. If the extract was diluted prior to reading on the fluorometer, the dilution factor (noted in the comments column) was applied at the end of the equation.
This file was created by Mark St. John at Colorado State University on 11 Nov 1998, using raw data from the Excel workbook '9511stca.raw'. The file format was suggested by the LTER data manager, to conform with the relational database structure. On 4 Dec 1998, the file was submitted to Denise Steigerwald, the MCM LTER data manager, located at INSTAAR, University of Colorado.
Upon arrival at INSTAAR, the data manager removed columns for latitude and longitude, and updated the location names to match those provided in the "soil measurement locations" file (from which latitude and longitude can be found). The resulting file was reformatted to present in ascii, comma delimited text and MS-DOS text (table layout) on the MCM LTER web site. Both of these files are linked to this web page above.
Dataset package migrated into the
Drupal Ecological Information Management System
in 2014, Inigo San Gil
about Chlorophyll-A Responses to Short-Term Soil Manipulation Experiment